Control

DPI in DNP 3.0 protocol

  • Thread starter Jose Calzadilla
  • Start date
J

Thread Starter

Jose Calzadilla

Why can't i implement a double point indication (DPI) in the DNP 3.0 protocol?

I need to address a final IED with operation Open/Close with the same point number, can i do that with DNP 3.0? if not, why?

Thank in advance...
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
U Thytronic Relays DNP Configurationn Electrical Engineering 0
F Problems with new analog scales en GE Powelink 3.04 DNP over Factory Link 6.5 General Software Chat 0
D DNP Secure Authentication MAC General Communications Chat 0
C Configuring BMXNOR0200H Module as DNP Slave at Different TCP Ports Programmable Logic Controller - PLC 0
S Communication between a HART transmitter using DRUCK DPI 610 24 voltage power source General Communications Chat 3
Similar threads
Thytronic Relays DNP Configurationn
Problems with new analog scales en GE Powelink 3.04 DNP over Factory Link 6.5
DNP Secure Authentication MAC
Configuring BMXNOR0200H Module as DNP Slave at Different TCP Ports
Communication between a HART transmitter using DRUCK DPI 610 24 voltage power source

You May Also Like

Top