Driver for Siemens 3964R protocol

R

Thread Starter

Rajeev

In one of our ongoing project we need to communicate with siemens PLC via serial interface using 3964R protocol. At our end we are using GE Fanuc 90-30 PLC. Please help!!!

 
D
You could use a 'black box' serial protocol converter. We have been using Red Lion Controls 'Babel Box' for several years. They are easy to set up and industrial strength! The units support about 80 common industrial serial protocols out of the box.

[email protected]
 
C

Curt Wuollet

Hmmmm.....

There is r3964 support of some kind in RH7.1 and I've done ccm with a 90/30. Perhaps a linux box as a bridge? Naw, that'd be too cheap :^)

Regards

cww
 
Z

Zan Von Flue

Hi
Looking at both sites (GE and Siemens) I found that both S5 and S7 from Siemens(I don't know which CPU or CP) and GE, both talk Modbus. Where for the small Siemens CPU's are RTU and slave format. If needed I can give you the Siemens web page. This could be easier.
later
zan
 
Top