Dear All,
I want to connect HMI with Emerson micro motion to display some parameters link mass flow rate, mass inventory , volume inventory etc.
Address for these registers given in manual are 20247/20248, 20263/20264, 20265/20266.
But when I enter these addresses in HMI, then it shows communication error/address error.
If I use address 1/2/3/4/5/...... then communication is fine but the values are not what I want to access.
can anyone help please.
Thanks
Shoaib
I want to connect HMI with Emerson micro motion to display some parameters link mass flow rate, mass inventory , volume inventory etc.
Address for these registers given in manual are 20247/20248, 20263/20264, 20265/20266.
But when I enter these addresses in HMI, then it shows communication error/address error.
If I use address 1/2/3/4/5/...... then communication is fine but the values are not what I want to access.
can anyone help please.
Thanks
Shoaib