Control.com

ET200

Search Forums New Posts
P

Thread Starter

pk

We are using a PC-based automation system where we are checking the temperature of a system by thermocouples. These t/cs are connected to the input card of a rack with ET200. Whenever any t/c is getting open it shows an SF fault on the card. When the t/c is replaced with a spare, this SF fault does not reset. What should I do?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
A AC800 with ET200 Programmable Logic Controller - PLC 1
J About ET200 of Siemens Programmable Logic Controller - PLC 4
T Looking for old com et200 software Programmable Logic Controller - PLC 1
Similar threads
AC800 with ET200
About ET200 of Siemens
Looking for old com et200 software

You May Also Like

Top