B
I'm in the process of converting an old HMI that was made in 1996 using FactoryLink ECS to the new RSView Studio SE. I desperately need to get the tag database out of the HMI application so that I don't have to manually enter in all those tags. I have never used FactoryLink ECS in the past and could not figure it out after hours of trying to export the database.
This implementation communications to a PLC5 over DH+ via a SST 5136-SD card (ISA slot). There were 3rd party communications drivers that were installed and I was told that I have to install these drivers to get the tag database out. This doesn't quite make sence to me, so can anyone verify this? The driver vendor can be found here:
http://www.axisware.com/awb/fldes18.htm
I tried installing it but it bugged out.
So... can anyone tell me if exporting the tag database is reliant on having that driver installed, and if not, what methods you'd use to export the database into a .csv (or similiar) format?
Thanks a million,
-Brian Cleven
Celco Controls
Toll Free: 1-866-99CELCO
[email protected]
This implementation communications to a PLC5 over DH+ via a SST 5136-SD card (ISA slot). There were 3rd party communications drivers that were installed and I was told that I have to install these drivers to get the tag database out. This doesn't quite make sence to me, so can anyone verify this? The driver vendor can be found here:
http://www.axisware.com/awb/fldes18.htm
I tried installing it but it bugged out.
So... can anyone tell me if exporting the tag database is reliant on having that driver installed, and if not, what methods you'd use to export the database into a .csv (or similiar) format?
Thanks a million,
-Brian Cleven
Celco Controls
Toll Free: 1-866-99CELCO
[email protected]