Control

Factorylink to AB ControlLogix 5500 processor

E

Thread Starter

Eduado Montenegro

I have the following question.

Is it possible to communicate with a PLC CONTROLLOGIX using the AB_RAPD DRIVER? or just using Factorylink OPC task ? I have configured one connection using AB_RAPD DRIVER to communicate with PLC ControlLogix, but did not work. I did this connection's configuration on the factorylink like i did others connections with PLC-5 (that are working).

I hope your answer.
Thanks
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
G Old, obsolete, factorylink 6.4, 6.6, etc. download Human Machine Interface - HMI 1
C Factorylink 3.0 Human Machine Interface - HMI 0
Y Omni Flow Computer MODBUS Addresses in Factorylink Modbus 2
J Upgrading FactoryLink ECS Human Machine Interface - HMI 5
R Factorylink to an AB ControlLogix 5500 processor?? Human Machine Interface - HMI 1
Similar threads
Old, obsolete, factorylink 6.4, 6.6, etc. download
Factorylink 3.0
Omni Flow Computer MODBUS Addresses in Factorylink
Upgrading FactoryLink ECS
Factorylink to an AB ControlLogix 5500 processor??

You May Also Like

Top