Control

Fanuc 6 rotary axis

D

Thread Starter

Dan K

Looking at a Horiz. machining center for retrofit
that has a pallet type rotary axis. Has anyone ever heard of a PLC controlled (5 deg. index)
rotary axis on the Fanuc 6m control? It is not
a servo controlled axis. Thanks
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S Matrikon OPC support Fanuc CNCs supports communications with multiple protocol networks, including Fanuc Focas 1 Ethernet and Fanuc Focas HSSB Open Platform Communications (OPC) 0
S Using PME 9.0 with GE Fanuc 90/30 Programmable Logic Controller - PLC 1
AxonControlEngineering ABB Infi90 DCS and GE Fanuc Rx7i hand-on experienced Freelancer is needed for a quick engagement General Automation Chat 0
X GE Fanuc Series 90-30 PLC using Proficy Machine Edition General Automation Chat 2
chathurais GE Fanuc 90-30 GNIU and IO carriers fault Programmable Logic Controller - PLC 0
Similar threads
Matrikon OPC support Fanuc CNCs supports communications with multiple protocol networks, including Fanuc Focas 1 Ethernet and Fanuc Focas HSSB
Using PME 9.0 with GE Fanuc 90/30
ABB Infi90 DCS and GE Fanuc Rx7i hand-on experienced Freelancer is needed for a quick engagement
GE Fanuc Series 90-30 PLC using Proficy Machine Edition
GE Fanuc 90-30 GNIU and IO carriers fault

You May Also Like

Top