Hello,

I have a GE Fanuc Series One Junior that I need to make changes to. I do not have a cable pinout or software to do so.

Any and all assistance would be greatly appreciated.

Thanks all.

 

I have a manual for the series one jr someplace, it's a bad scan but if I can find it I'll post. These are a Koyo and very similar to the Automation Direct PLCs. In fact I was able to make an audio tape backup from a series one jr and restore it to an AD PLC. I would expect the cables, etc. to be similar.

Regards
cww

 

I have contacted Automation Direct, and they said that they have no support for the Juniors, just series one. Not sure where that leaves me.

 

There is a manual and a hand-held programmer.
For the Junior you don't need much more.
The programmer used on the Series One is the same for the Junior. You can still find those on the Internet. (Watch the link below.)

What kind of program do you need? Do you have a sketch?

My e-mail is artespf @ aol. com

http://www.qualitrol.com/html/prod_results.asp?Product_Line=Series One

 

I did find my scanned manual. I can mail it if you like.

Regards

cww