P
Is it possible to install totalizer with one Micromotion meter and one Motor operated control valve? The operation philoshopy is like this.
[1] We Preset the 25000 Lts. of set point and push START.
[2] The MOV (480 volt motor) open and flow of the material start.
[3] As soon as 25000 lts of material pass via MMM, the MOV should CLOSE.
In short, it is a close loop.
Could some one suggest some Controller/Totalizer (with Printer) for this application?
[1] We Preset the 25000 Lts. of set point and push START.
[2] The MOV (480 volt motor) open and flow of the material start.
[3] As soon as 25000 lts of material pass via MMM, the MOV should CLOSE.
In short, it is a close loop.
Could some one suggest some Controller/Totalizer (with Printer) for this application?
