Frame 6 Dual Fuel (Gas/Fuel Oil) Conversions


Thread Starter

Terry Meikle

1. I am searching out "User/Owner" experience in converting Frame 6 DLM units to dual fuel.

2. Who did the conversion?

3. Was there an Engineering firm involved in Balance of Plant engineering "BOP", if so who?

4. Did a General Contractor perform BOP work, if so who?

5. Did you install a new accessory gear box or did you modify the existing gear box to drive the atomizing air compressor?

6. How is the starting atomizing air compressor powered?

7. Were there any problems obtaining required NOx emission requirements?

8. Can I visit your site?