R
I need to modify the PLC code on
the Series 18-MA and an 18-TA controls. I am aware that the code is on eprom (1 or 2? type?) but have never done this before. I have used the same kit (different fapt S/W) to modify the code an a Series 0-MC, I guess the process is similar?
I believe I have the correct fapt-ladder software and eprom burner & cables (bought from Fanuc years ago when purchasing the machine tool)
I would appreciate any advice, guidance, procedures, do's and dont's etc. from anyone who has done this before.
Regards, Richard.
the Series 18-MA and an 18-TA controls. I am aware that the code is on eprom (1 or 2? type?) but have never done this before. I have used the same kit (different fapt S/W) to modify the code an a Series 0-MC, I guess the process is similar?
I believe I have the correct fapt-ladder software and eprom burner & cables (bought from Fanuc years ago when purchasing the machine tool)
I would appreciate any advice, guidance, procedures, do's and dont's etc. from anyone who has done this before.
Regards, Richard.