Control

GE Fanuc Conversion From Eclips to CIMPLICITY

A

Thread Starter

Anonymous

Hi all,

I was wondering if any of you out there had done a application migration from Adatek Eclips to GE CIMPLICITY Machine Edition State. After the migration, my PID loops are out of control. I am using the same tuning constants. The Eclips code on a CSE784 was running at 400 ms per sweep. The CME code on a CPX935 is running at 4 ms per sweep. I suspect that the sweep time had something to do with it. But I slowed the new code down to 400 ms. Still no help.

I don't know if any of you had run into this problem before. If so, please help. I don't want to re-tune. There are way too many loops.

Thanks.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S Matrikon OPC support Fanuc CNCs supports communications with multiple protocol networks, including Fanuc Focas 1 Ethernet and Fanuc Focas HSSB Open Platform Communications (OPC) 0
S Using PME 9.0 with GE Fanuc 90/30 Programmable Logic Controller - PLC 1
AxonControlEngineering ABB Infi90 DCS and GE Fanuc Rx7i hand-on experienced Freelancer is needed for a quick engagement General Automation Chat 0
X GE Fanuc Series 90-30 PLC using Proficy Machine Edition General Automation Chat 2
chathurais GE Fanuc 90-30 GNIU and IO carriers fault Programmable Logic Controller - PLC 0
Similar threads
Matrikon OPC support Fanuc CNCs supports communications with multiple protocol networks, including Fanuc Focas 1 Ethernet and Fanuc Focas HSSB
Using PME 9.0 with GE Fanuc 90/30
ABB Infi90 DCS and GE Fanuc Rx7i hand-on experienced Freelancer is needed for a quick engagement
GE Fanuc Series 90-30 PLC using Proficy Machine Edition
GE Fanuc 90-30 GNIU and IO carriers fault

You May Also Like

Top