Control

Gearing on 1500 KW Motor

A

Thread Starter

Ali

we using a 1500 KW Motor on Cane cutter, 990rpm, 3300volt. there are high load variation. If we use a gear ration 1:1, are it control the high torquing and beneficiary?
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
V S7-1500 changing IP Address Programmable Logic Controller - PLC 1
P Connecting Honeywell UDC2500 via Modbus TCP/IP to Siemens S7-1500 Modbus 1
B Panel View Plus 1500 Alarm Page Human Machine Interface - HMI 1
S S7-1500 CM541 Serial RS232 ASCII help General Communications Chat 0
R Reducing position following error in electronic gearing Motion Control 1
Similar threads
S7-1500 changing IP Address
Connecting Honeywell UDC2500 via Modbus TCP/IP to Siemens S7-1500
Panel View Plus 1500 Alarm Page
S7-1500 CM541 Serial RS232 ASCII help
Reducing position following error in electronic gearing

You May Also Like

Top