C
Hi All
As I work with a lot of equipment from overseas manufacturers, I have noticed some common practices in their schematic drawings for large machines. Every time I think I have it all ironed out, I run into something confusing. I know they make sense, but what I got to wondering was:
Is this because of some standard, or merely custom?
Is there some resource for common practices? In English?
I will probably be working with them enough to become expert soon, but I'd like to get a leg up so I can hit the ground running.
Regards
cww
As I work with a lot of equipment from overseas manufacturers, I have noticed some common practices in their schematic drawings for large machines. Every time I think I have it all ironed out, I run into something confusing. I know they make sense, but what I got to wondering was:
Is this because of some standard, or merely custom?
Is there some resource for common practices? In English?
I will probably be working with them enough to become expert soon, but I'd like to get a leg up so I can hit the ground running.
Regards
cww