Control

How do I get the XMIT function block?

A

Thread Starter

Abelardo

As I understand the only way to write/read data between a compac and a quantum is by using the XMIT function block; but it isn't listed in the tools available. ¿How can I get that instruction?
I'm using proworx nt.
 
S

sdb83065

The older compac processors required a loadable for XMIT block I dont believe the new modules require it but since you cant see the function block you need the loadable installed. You can use the peer cop extension if you have a ModbusPlus port instead of the Xmit function.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
M Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND Power Generation 27
F MARK VI Turbine with Alarm XMIT Power Generation 2
J Loadables for adding XMIT Block for Modicon Concept 2.6 SR3 General Software Chat 0
T TCCA Status S page xmit failure Power Generation 3
A XMIT function block General Communications Chat 3
Similar threads
Diagnostic signal controller MARK-VI ALARM XMIT SUSPEND
MARK VI Turbine with Alarm XMIT
Loadables for adding XMIT Block for Modicon Concept 2.6 SR3
TCCA Status S page xmit failure
XMIT function block

You May Also Like

Top