What could be the reason for the Image mismatch error occuring during the loading of FCS in YOKOGAWA DCS?

How to remove this error? Is there any method by which I can take download the running FCS program on a DAT... The backup procedure that is followed copies the builder of the EWS as far as I know. Can I download the running FCS program onto the HD of the EWS and then take a back up of the same?

 

There is a solution at
"http://www.automated.com.au/faqs-time-stamp.htm":http://www.automated.com.au/faqs-time-stamp.htm

And no, you can't (to my knowledge) upload the FCS image.

 

The simplest way to remove the image mismatch error is to give an offline load to the FCS but make sure to take the backup before doing the load. This works for the Centium CS too.