Control

Inductive part ID systems

C

Thread Starter

c brown

anyone have any experience with pepperl+fuchs inductive part ID proxes, specifically interfacing with AB slc's. Or any other vendor have a better product? Looking to "part ID" dies in a mechanical press and load all parameters from this sensor.

thanks
 
T

Tim Cicerchi

I have a lot of experience with these products. The SLC 500 series has a bunch of connections to our ID systems including through Channel
0, DeviceNet, Remote IO. You can even get a Profibus or Interbus connection if you were so inclined.

Please provide more information on part numbers and the specific problem so I can give you some assistance.

Best regards

Tim
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
runescape Do inductive motor fields damage laptop's SSD (vs HDD)? Motion Control 3
A Install a 4-wire inductive sensor instead of a 5-wire Sensors & Calibration 0
S DC to DC converter for inductive loads. (12 V DC to 24 V DC) Electrical Engineering 3
Zeshan2050 Generator Power Factor drops to 0.3 On Inductive Load. Power Generation 2
R Balluff Inductive Sensor with 4 Wires Sensors & Calibration 1
Similar threads
Do inductive motor fields damage laptop's SSD (vs HDD)?
Install a 4-wire inductive sensor instead of a 5-wire
DC to DC converter for inductive loads. (12 V DC to 24 V DC)
Generator Power Factor drops to 0.3 On Inductive Load.
Balluff Inductive Sensor with 4 Wires

You May Also Like

Top