P
Hi all-
We are searching to find an insertion flowmeter wich can be inserted in a 1 inch hole.
The product is fresh water, press=80 lbs
Length is 18 inch insertion ...
Pipes are 24 inches to 108 inches, cast iron to cement ...
We will feed the data to a SCADA system trough wireless link.
The units will be mobile (they will change location depending on needs...)
We need 40 units but what we have been proposed was magflow which are not precise under 0.15 M/min.
Is there another way to do this ?
What about thermal massflow for water ?
Thanks !
Pierre
[email protected]
We are searching to find an insertion flowmeter wich can be inserted in a 1 inch hole.
The product is fresh water, press=80 lbs
Length is 18 inch insertion ...
Pipes are 24 inches to 108 inches, cast iron to cement ...
We will feed the data to a SCADA system trough wireless link.
The units will be mobile (they will change location depending on needs...)
We need 40 units but what we have been proposed was magflow which are not precise under 0.15 M/min.
Is there another way to do this ?
What about thermal massflow for water ?
Thanks !
Pierre
[email protected]