R
I have E1 message (power failure) on display when connect power supply. The upper two green LEDs
is on and the red LED in the middle flashes.
I check power on X5 connector terminal 3&8 but dont voltage.when ACK disply and go to Event
message only have one message that is :
L/C input<min.
HOW i can diagnose and find the fault?
thanks
is on and the red LED in the middle flashes.
I check power on X5 connector terminal 3&8 but dont voltage.when ACK disply and go to Event
message only have one message that is :
L/C input<min.
HOW i can diagnose and find the fault?
thanks