Control

Interfacing of MARK IV with DCS

R

Thread Starter

Ritesh Vyas

Sir,

Could you please give me some information about the paramaters of Mark IV which can be transmitted to DCS, i.e. Honeywell TDC 3000 via fiber optic link? We already have this thing in our Mark IV. We wish to have some more points to be added to that. Is there any list kind of thing available that contains the paramaters which can be transmitted for remote indication?
 
C

CSD

It has been a long time since i worked on Mark IV, but I remember in the Mark IV Elementaries (probably 19 sheets) give a list of parameters, which can be transmitted to DCS. Also not sure whether you can add any points to the existing list.
 
C

CSD

There should be two modems (LDDS-Limited distance data sets which are to be located one in Mark IV panel and the other in the DCS panel. These two modems are hard wired through a signal cable.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
J Interfacing with a GE Mark VI Power Generation 12
R Interfacing GE's Mark System with DCS/SCADA Distributed Control Systems - DCS 3
R Interfacing of Mark VIe controller with Honeywell HPM Networking 1
A Speedtronic Mark IV Interfacing General Communications Chat 4
K Interfacing to a GE Speedtronic Mark II General Communications Chat 4
Similar threads
Interfacing with a GE Mark VI
Interfacing GE's Mark System with DCS/SCADA
Interfacing of Mark VIe controller with Honeywell HPM
Speedtronic Mark IV Interfacing
Interfacing to a GE Speedtronic Mark II

You May Also Like

Top