L
Hi,
I have a SIMATIC PANEL PC670 that runs Wonderware and due to some obsolete hardware I need to change the HMI, and I would like to convert the software to Siemens WinCC.
Can a conversion be achieved?
The HMI is currently running on WIN NT 4.0 and Intouch 7.1 I have no experience of Wonderware only Siemens.
Any advice would be greatly appreciated
Regards
Lee
I have a SIMATIC PANEL PC670 that runs Wonderware and due to some obsolete hardware I need to change the HMI, and I would like to convert the software to Siemens WinCC.
Can a conversion be achieved?
The HMI is currently running on WIN NT 4.0 and Intouch 7.1 I have no experience of Wonderware only Siemens.
Any advice would be greatly appreciated
Regards
Lee