S
Hi:
We are designing an adhesive dispensing system which requires the glue head to be at a constant distance from the surface where glue will be deposited. I am thinking of using a range sensor but wonder if this is really necessary. Further, I am not quite sure how to use this measurement anyway since most commercial motion control boards normally take the feedback signal from the motor encoder.
So I would appreciate if anyone could tell me if range sensor is really needed in this application. And, if so, how should I proceed?
Thank you very much
Suttipan.
We are designing an adhesive dispensing system which requires the glue head to be at a constant distance from the surface where glue will be deposited. I am thinking of using a range sensor but wonder if this is really necessary. Further, I am not quite sure how to use this measurement anyway since most commercial motion control boards normally take the feedback signal from the motor encoder.
So I would appreciate if anyone could tell me if range sensor is really needed in this application. And, if so, how should I proceed?
Thank you very much
Suttipan.