F
Hi,
I am supposed to log data from a hand held tachometer with serial port.
The problem is that nothing can be read from the port. I have tried many times. I am using labview for reading the port. I tried Hyperterminal many times. I tried both upper and lower
cases. I also changed the ASCII settings etc. Actually the manual says the following command
sequence in order to retrieve data from the meter:
STX x H n ETX
Where 'n' and 'x' are switches and could be one of five numbers from 1 to 5. Each number has own
meaning like send average, send continuous etc. and i tried all.
Baud is 4800, 8 data bits, no parity, 1 stop bit and no XON or XOF etc. The meter is Braun MOVIPORT and has no custom Software. I Look forward to hear from someone soon.
Faisal.
I'll appreciate any help in this regard.
I am supposed to log data from a hand held tachometer with serial port.
The problem is that nothing can be read from the port. I have tried many times. I am using labview for reading the port. I tried Hyperterminal many times. I tried both upper and lower
cases. I also changed the ASCII settings etc. Actually the manual says the following command
sequence in order to retrieve data from the meter:
STX x H n ETX
Where 'n' and 'x' are switches and could be one of five numbers from 1 to 5. Each number has own
meaning like send average, send continuous etc. and i tried all.
Baud is 4800, 8 data bits, no parity, 1 stop bit and no XON or XOF etc. The meter is Braun MOVIPORT and has no custom Software. I Look forward to hear from someone soon.
Faisal.
I'll appreciate any help in this regard.