B
I'm using a MO2AE for controlling hydraulic proportional valve based on encoder feedback. I have been able to recieve counts without trouble in feedback only mode.
I need some direction in seting the module up for controlling the valve. When I switch to Servo-Output, I get differen't than expected values for the command. After about 4 inches of stroke, the module faults on feedback error.
The 196 page manual, although detailed, is geared to using this card with an A/B drive and motor. This is where I am having trouble understanding what the parameters are actually doing and which ones are a must to even get a jog command out of the card.
Does anyone know of a site, document, or have experience with a "getting started" type guide or application document? Any information or suggestions will be helpful.
I need some direction in seting the module up for controlling the valve. When I switch to Servo-Output, I get differen't than expected values for the command. After about 4 inches of stroke, the module faults on feedback error.
The 196 page manual, although detailed, is geared to using this card with an A/B drive and motor. This is where I am having trouble understanding what the parameters are actually doing and which ones are a must to even get a jog command out of the card.
Does anyone know of a site, document, or have experience with a "getting started" type guide or application document? Any information or suggestions will be helpful.