S
Help!!!
Sorry for the long winded post.
I have encountered an MEM fault on an old Telemecanique TSX47-420 PLC after a 6 hour power outage. I have tried the following with no success,
1. Reload Program - error message in xtel- 15026 Reservation PL7-3 not possible.
2. Re-Initialise processor- error message in xtel- 15034 Init has not been effective.
3. Replaced Processor and RAM module- Same fault appears.
4. Replaced Batteries on RAM Module and Processor- Same fault appears.
Xtel is communicating fine with the processor as I am seeing the correct processor come up when I connect to each of the different versioned processors I have tried.
I have a complete line down in my facility at this time losing thousands an hour, any help would be appreciated.
Regards,
Scott
Sorry for the long winded post.
I have encountered an MEM fault on an old Telemecanique TSX47-420 PLC after a 6 hour power outage. I have tried the following with no success,
1. Reload Program - error message in xtel- 15026 Reservation PL7-3 not possible.
2. Re-Initialise processor- error message in xtel- 15034 Init has not been effective.
3. Replaced Processor and RAM module- Same fault appears.
4. Replaced Batteries on RAM Module and Processor- Same fault appears.
Xtel is communicating fine with the processor as I am seeing the correct processor come up when I connect to each of the different versioned processors I have tried.
I have a complete line down in my facility at this time losing thousands an hour, any help would be appreciated.
Regards,
Scott