Mitsi V-500 VSD pos control and master slave

S

Thread Starter

Stuart Cornell

The Mitsubishi V-500 is a very new drive here in Australia. So much so, documentation and manuals for the product are not available yet. I am looking to use the drives in positional control mode, where a target destination is sent to the drive from a plc over a Profibus network.

Can anyone tell me if this is possible?

Also, we are looking to use the drive in Master-Slave mode for some equipment. I do not know if this is an option. Does anyone know about the V-500 drive and what it can do.
 
Top