I'm doing a project where I need to perform the communication between a FCS centum VP R6 with 49 WAGO 750-352 modules in a Modbus TCP network with ring topology. I'm using the ALE111 module. The architecture is already consolidated, however I need help with the software, how to configure the ALE111 card to communicate with these modules and how the "comunication I / o Builder" should be configured. I would be grateful if anyone can give a tip, or an example about it.
Modbus TCP communication between Yokogawa FCS centum VP R6 and WAGO 750-352 module.
- Thread starter renansenaa
- Start date
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
| J | HMI Modbus TCP/IP Device Communication | Modbus | 7 | |
| V | Modbus TCP/IP communication to Kongsberg BMS | Instrumentation & Measurement | 0 | |
|
Establishing Modbus TCP communication | Modbus | 12 | |
| A | Modbus TCP/IP Client to Client communication | Modbus | 4 | |
| S | Modbus TCP/IP Communication Over Fibre Optic System | Modbus | 2 |
