Control

Modbus TCP/IP using Mvi56-WA-PWP /Prolinx MNET/Mvi56-MNET

R

Thread Starter

roe

Dear all,
I'm new here..nice to meet you all and I need help.

I want to connect CLX. I use MVI56-WA-PWP on CLX side --> connected it via wireless to Prolinx-WA-MNET --> DCS Modbus TCP/IP

Since I don't have modbus TCP/IP device, I use MVI56-MNET for simulation.

Does any of you ever do this kind of configuration? May I know the right configuration?

I really appreciate your help

regards,
roe

 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
T GE Rx3i (Proficy ME 9.5): Protocol for reading floating points from power monitor using Modbus TCP Modbus 1
patrickduis Using both Modbus TCP and Profinet on the same ethernet cable Modbus 1
C MODBus TCP to BACNet IP Gateway Using v6 IP addresses Modbus 2
A Serial to MODBUS TCP Converter using Wiznet W5500 Modbus 0
H Communication Issue Using MODBUS TCP Modbus 2
Similar threads
GE Rx3i (Proficy ME 9.5): Protocol for reading floating points from power monitor using Modbus TCP
Using both Modbus TCP and Profinet on the same ethernet cable
MODBus TCP to BACNet IP Gateway Using v6 IP addresses
Serial to MODBUS TCP Converter using Wiznet W5500
Communication Issue Using MODBUS TCP

You May Also Like

Top