Hi,
When reading from a coil, what should I put in the "Multibyte Length" which is shown under the "Modbus Data Point Parameters" in my software?
Since I am reading a coil, the associated modbus address (0*4053 in this case) contains only one bit. So, I don't have a multibyte to read from! It is only one bit.
When reading from a coil, what should I put in the "Multibyte Length" which is shown under the "Modbus Data Point Parameters" in my software?
Since I am reading a coil, the associated modbus address (0*4053 in this case) contains only one bit. So, I don't have a multibyte to read from! It is only one bit.