Control

Multicast Network Traffic from Allen Bradley Controls

S

Thread Starter

SkyQuake

Hello:

We have a lot of Allen Bradley equipment sending out traffic from multicast addresses. Theoretically, this traffic is supposed to make the network more efficient, if the network switches are configured to route it properly. How could this best be accomplished with Cisco switches?... I suppose every AB controller would be considered a source, but how are the multicast addresses given to the AB equipment?

Thanks
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
MarcoMontemurro Communication lost with all devices In a modbus rtu network when one of the devices went off Modbus 2
P ABB PGP HMI Network Discrepancy - Seeking Configuration Assistance Distributed Control Systems - DCS 0
A A master system missing, Three PLCs communicate with each other through ethernet network, is that a DCS Distributed Control Systems - DCS 2
J Is multicast used in BECKHOFF/WAGO via Modbus/TCP Modbus 5
R GE-EGD Unicast and GE-EGD Multicast General Communications Chat 1
Similar threads
Communication lost with all devices In a modbus rtu network when one of the devices went off
ABB PGP HMI Network Discrepancy - Seeking Configuration Assistance
A master system missing, Three PLCs communicate with each other through ethernet network, is that a DCS
Is multicast used in BECKHOFF/WAGO via Modbus/TCP
GE-EGD Unicast and GE-EGD Multicast

You May Also Like

Top