J
Could anyone help me with this (probably) incredibly simple electrical problem?
I need to up-scale a signal from a A/D board from 0-5 ma to (0) 4- 20 ma to
drive an FMC vibratory feeder controller. FMC gave me a schematic for using
the alternative 0-10 volt input, but my technican can't figure it out. I've
been in India for three weeks, and should get your repplay about when I get
back to the states to try to tackle this.
(If this sounds stupid, it's because I'm a Chem E, not a elctrical
technician... )
=>Jim<= Now in Amsterdam for a few
days....
I need to up-scale a signal from a A/D board from 0-5 ma to (0) 4- 20 ma to
drive an FMC vibratory feeder controller. FMC gave me a schematic for using
the alternative 0-10 volt input, but my technican can't figure it out. I've
been in India for three weeks, and should get your repplay about when I get
back to the states to try to tackle this.
(If this sounds stupid, it's because I'm a Chem E, not a elctrical
technician... )
=>Jim<= Now in Amsterdam for a few
days....