Control

Need Ladder Logic example for Modbus

R

Thread Starter

Roger

i'm trying to control a Lenze (AC-Tech) servo drive with Automation Direct D2-260 using Directsoft5 RS485 Modbus. i don't know what to write in the Ladder Logic to communicate with the drive. i need to give the drive a position to go to, then receive when it's in position, etc. Do i need to monitor the encoder or just hook it to the drive? If not how will i know what the position is? i don't know anything about Modbus and don't know where to start. Any examples? please HELP!
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Shihabe3400 I have problème and i need help please Power Generation 1
M Need help unidrive sp1422 Motion Control 0
C Need some help with ladder diagrams Programmable Logic Controller - PLC 6
W Hi , I have a challenge , i need to measure voltage of car battery by using plc fx 2n mitsubish , with devices is needed and which ladder logic is use General Automation Chat 10
A Need help identifying PLC type from ladder only Programmable Logic Controller - PLC 2
Similar threads
I have problème and i need help please
Need help unidrive sp1422
Need some help with ladder diagrams
Hi , I have a challenge , i need to measure voltage of car battery by using plc fx 2n mitsubish , with devices is needed and which ladder logic is use
Need help identifying PLC type from ladder only

You May Also Like

Top