P
I need some ideas for an accurate, repeatable drive system. I need max. 6 Nm torque. The duty cycle of the motor will be very low and the velocity is really an issue. I need to move between 10 - 20 degrees with an accuracy of 1%.
Ideally I would like to control the drive position via a Siemens step7 PLC via profibus or MPI. If not I would consider another comms protocol.
If this is still not possible then I would consider a separate control system for just handling the drive positioning, providing it's not too expensive.
Has anyone got any experiance of such an animal??
Ideally I would like to control the drive position via a Siemens step7 PLC via profibus or MPI. If not I would consider another comms protocol.
If this is still not possible then I would consider a separate control system for just handling the drive positioning, providing it's not too expensive.
Has anyone got any experiance of such an animal??