O2 Analyser Reading


Thread Starter


We have a O2 Analyzer of Emerson Make of series Oximitter 4000. It is installed in Utility Boiler as supplied by BHEL. Generally Oxygen keep in 3%. But sometimes reading shows 0% for only 10 sec. After that it again regain shows 3%. We did calibration of the O2 and calibration comes successful. But after 3 Days again calibration recommended coming and calibration LED blink.

Please suggest why it shows 0% for a while?
You don't per chance have an auto calibration going on?

William (Bill) L. Mostia, Jr. PE
ISA Fellow, SIS-TECH Fellow,
FS Eng. (TUV Rheinland)
SIS-TECH Solutions, LP

"No trees were killed to send this message, but a large number of electrons were terribly inconvenienced." Neil deGrasse Tyson

Any information is provided on a Caveat Emptor basis.