S
Hello,
we have a project were it is required to control a matrix of 80x80 cylinders. Each cylinder has a 0-100% force. Since there are multiple models, recipes are needed.
To create the recipe, I was thinking on a 80x80 grid, were the operator draws lines and polygons to determine the use of the cylinders.
then each "pixel" will correspond to a variable/cylinder and its just a PLC normal work.
Do you know any OCX or method to do this?
Thanks in advance
Sergio
[email protected]
we have a project were it is required to control a matrix of 80x80 cylinders. Each cylinder has a 0-100% force. Since there are multiple models, recipes are needed.
To create the recipe, I was thinking on a 80x80 grid, were the operator draws lines and polygons to determine the use of the cylinders.
then each "pixel" will correspond to a variable/cylinder and its just a PLC normal work.
Do you know any OCX or method to do this?
Thanks in advance
Sergio
[email protected]