M
Hi,
I'm looking for documents of Seiberco AIM LX 5000 series. I found those servo drivers in my old storage. They still in good condition (look like new). And the Ready led still green with no fault when I connected them to powerline. But when i tried to rotate the motor by pulse signal in CN3-2, CN3-4; or connect to the COM port on my PC, and i used putty software. They just send back only "w" character at very first start. If I send a bunch of characters (about 77 chars), another 2 characters "vw" back. Is there anyone can help me?
Please email: [email protected]
I'm very very appreciate!
I'm looking for documents of Seiberco AIM LX 5000 series. I found those servo drivers in my old storage. They still in good condition (look like new). And the Ready led still green with no fault when I connected them to powerline. But when i tried to rotate the motor by pulse signal in CN3-2, CN3-4; or connect to the COM port on my PC, and i used putty software. They just send back only "w" character at very first start. If I send a bunch of characters (about 77 chars), another 2 characters "vw" back. Is there anyone can help me?
Please email: [email protected]
I'm very very appreciate!