R
having an Omron controller link network setup between several PLC's, i am wondering if a can monitor but also program via one single ethernet module connected to one of the PLC's (providing they support the module) and thus via a PC on a LAN?
I know this can be achieved via a serial link to any of the PLC's on the network, but would also like to do the same via a PC in the office via ethernet and therefore possibly a scada package.
Thanks.
I know this can be achieved via a serial link to any of the PLC's on the network, but would also like to do the same via a PC in the office via ethernet and therefore possibly a scada package.
Thanks.