Control

omron nt20m problem

A

Thread Starter

ALAIN FORTIN

I was erase all data in the terminal nt20m and i see now on screen "NO DIRECT INFORMATION IS SET". Can anybody help to communicate with it with the "SUPPORT TOOL PROGRAM". Ex: setting dip switch etc.
 
L

Luigi Faccio

you need to specify two special areas, named "PT control area" and "PT notify area". Using the NT Support Tool Dos version here the steps:
1- create a new program file (if this is your case);
2-press the F10 key (Next)
3-press the F2 key (Direct)
the first two parameter in the dialog window are the ones you need to specify. Save and transfer to the terminal
hope this can help you
regards,Luigi Faccio
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
D Omron e5ax temp controller repair General Automation Chat 2
J Omron CQM1H - NOS purchase - ERR/ALM LED On - Program Transfer Problems Programmable Logic Controller - PLC 2
S Omron NT20M Programmable Logic Controller - PLC 2
Y Omron operator interface NT20M Programmable Logic Controller - PLC 0
P OMRON NT20M to NT20S conversion Programmable Logic Controller - PLC 2
Similar threads
Omron e5ax temp controller repair
Omron CQM1H - NOS purchase - ERR/ALM LED On - Program Transfer Problems
Omron NT20M
Omron operator interface NT20M
OMRON NT20M to NT20S conversion

You May Also Like

Top