Control

Omron temp controller communication with omron plc

K

Thread Starter

karikalan

How to communicate omron E5ZN with any omron PLC. I need information about this. I have checked with E5ZN operational manual, that doesn't have any detail message about communication with PLC.
 
B

BobB

I do not know which manual you have but if you ga to http://oeiweb.omron.com/ there is an extensive document library available. You need manual H113-E1-1 for full communications protocol.
There is also a Device Net version available.
If my memory serves me correctly, Omron CX-Protocol has a communications protocol already written into it for this controller. CX-Protocol allows you to write protocols for any serial interface from a standard Omron serial port. For the CS1 and CJ1 an on board serial card is available with 2 ports. 1 port is RS232 and the other port can be RS232, 422 or 485.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
D Omron e5ax temp controller repair General Automation Chat 2
J Omron CQM1H - NOS purchase - ERR/ALM LED On - Program Transfer Problems Programmable Logic Controller - PLC 2
E Omron cj1m peripheral connection error Programmable Logic Controller - PLC 0
J 3G3MV Omron protocol macro Modbus 3
psycho Trying to understand Omron Modbus RTU Protocol Macro Modbus 4
Similar threads
Omron e5ax temp controller repair
Omron CQM1H - NOS purchase - ERR/ALM LED On - Program Transfer Problems
Omron cj1m peripheral connection error
3G3MV Omron protocol macro
Trying to understand Omron Modbus RTU Protocol Macro

You May Also Like

Top