R
I need to design a op-amp circuit that can double my input signal of .60 V to 1.0V, to a suitable voltage for a input to A/D converter. If any one has any ideas or circuit design would you reply please
thanks
thanks
Thread starter | Similar threads | Forum | Replies | Date |
---|---|---|---|---|
S | Panel-mount Volt/Amp Meter Sourcing | Sensors & Calibration | 4 | |
R | Replacing a 25 Amp Single Pole Contactor | General Automation Chat | 2 | |
W | 4-20 m amp transmitter fluctuation | General Automation Chat | 9 | |
J | Reading AMP Draw 230 VAC 1 ph | General Automation Chat | 2 | |
E | ABB Servo Amp | Motion Control | 2 |