Control

Operate PID loop in PLC5 via Modbus from Honeywell DCS

Y

Thread Starter

YuS

Just got such request from Customer.

For now we have standalone package (Heater Control) with 3 PID loops implemented in A-B PLC5 and most critical data transmitted to HPM via Modbus for alarming/archiving purposes.

I guess 2 more registers (Setpoint & Output) and 1 coil (Mode) can be configured to write new values from DCS to PLC... so how complicatated would be PLC logic changes? Any potential problems? Did somebody tried that scenario before?

Thanks,
Yuri
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
D Apply a forced signal to manually operate and fully open the GE gas turbine IGV General Automation Chat 3
Ephraim Hello please, how do I wire dc electrical motor, so that the dc motor shaft can operate with precision like a stepper motor ? General Automation Chat 5
N Remote Operate Control Valve General Automation Chat 1
M DSLC from Woodward Not Operate in Droop? Power Generation 9
E What happen when 60 hz motor operate at 50 Hz General Automation Chat 1
Similar threads
Apply a forced signal to manually operate and fully open the GE gas turbine IGV
Hello please, how do I wire dc electrical motor, so that the dc motor shaft can operate with precision like a stepper motor ?
Remote Operate Control Valve
DSLC from Woodward Not Operate in Droop?
What happen when 60 hz motor operate at 50 Hz

You May Also Like

Top