Hi,
Does anyone have the experience to set up the PCDI communication between the Honeywell C300 and the Safety Manager? We have built a PCDI master block, 2 PCDIFLAGARRCH, and one PCDINUMARRCH, but they did not talk. This is R154.3 redundant safety manager program to Honeywell R520.1. Here are the setting we have
PCDI master block (PCDI_Master):
1. Device Type: Redundant Safety Manager
2. The Primary/Secondary TCP port: 502
3. Two IP addresses are set the same as the safety manager COM 1A.
PCDIFLAGARRCHA:
1. Master Block Name: PCDI_Master
2. Channel number: 0
3. Device Address: 4 (Safety Manager controller node number is 1)
4. Starting Element Index: 210 (This is Safety Manager discrete output starting PLC address)
5. Number of Flag Values: 500 (number of DIGACQ blocks in the CM)
Could anyone help and advise?
Thanks & Regards,
Ryan
Does anyone have the experience to set up the PCDI communication between the Honeywell C300 and the Safety Manager? We have built a PCDI master block, 2 PCDIFLAGARRCH, and one PCDINUMARRCH, but they did not talk. This is R154.3 redundant safety manager program to Honeywell R520.1. Here are the setting we have
PCDI master block (PCDI_Master):
1. Device Type: Redundant Safety Manager
2. The Primary/Secondary TCP port: 502
3. Two IP addresses are set the same as the safety manager COM 1A.
PCDIFLAGARRCHA:
1. Master Block Name: PCDI_Master
2. Channel number: 0
3. Device Address: 4 (Safety Manager controller node number is 1)
4. Starting Element Index: 210 (This is Safety Manager discrete output starting PLC address)
5. Number of Flag Values: 500 (number of DIGACQ blocks in the CM)
Could anyone help and advise?
Thanks & Regards,
Ryan