Please help me with CMOS EPROM blowing

R

Thread Starter

rammy

Hi guys,

I came up to install a new program in the S5 PLC 948 cpu. I am trying to transfer the program blocks to the EPROM module on the Prommer (blow) which I had done before, but this time after erasing in the UV lamp I tried the block. It's displaying the following message:
DIRECTORY END ADDRESS 00000004
140D Wrong mode.

I even tried to change mode in the presets from 'word' to 'byte' to no avail. Auxiliary functions transfer will come up with:
DIRECTORY END ADDRESS 00000004
140C Submodule contents invalid.

I have checked in the manual as well got nothing useful so far.
 
Top