Control

Problem copying PLC instruction from Delta DVP14SS to DVP14SS2

Heisenberg

Thread Starter

Heisenberg

I first read from the 14SS PLC, and gather the ladder instructions.

I then connect the 14SS2 PLC, and attempt to write that instruction to the plc, and I get the error message:
Memory capacity does not correspond with model type!

I have compiled the instruction also.

I am new to Delta PLC programming, of anyone could offer some assistance it would be greatly appreciated.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
R Problem with thrust measurement - Bently 3300 XL Instrumentation & Measurement 0
zhenpingd45 Problem of oyostepper stepper motors connection Modbus 0
N MARK-V unwanted Logic forcing problem Programmable Logic Controller - PLC 4
S Mark V Simplex logic forcing problem Power Generation 4
K Problem to Solve General Automation Chat 0
Similar threads
Problem with thrust measurement - Bently 3300 XL
Problem of oyostepper stepper motors connection
MARK-V unwanted Logic forcing problem
Mark V Simplex logic forcing problem
Problem to Solve

You May Also Like

Top