Programming a EX40-Plus Toshiba PLC

M

Thread Starter

Marco Zaragoza

I´ve read that this PLC is similar to the D100CR40 Cutleer Hammer, so i might get the hand held for the cutler hammer PLC, may it be useful to reprogram the toshiba PLC.

Does anybody know how to get EX-PDD to access via PC, is there necessary a special interface??
 
They are very near identical and the software you mentioned will work but, yes, it does require a special interface to connect to a PC. The handheld
programmer connects direct with no interface. The manual for the PLC are available on toshiba's website as well as the EX-PDD software.
 
Top