A
I have a Feed and Cut application and I’m planning to use a Stepper Motor with its Stepper Drive.
I will like to use an Allen Bradley Micrologix 1500 PLC and control the pulses to the motor via the two 20 KHz Pulse Width Modulation output found within Micrologix 1500.
Does any of you have a sample file or perhaps some comments on how to use this two High Speed outputs?
Any reply will be highly appreciated.
Thanks
Andy
Puerto Rico
I will like to use an Allen Bradley Micrologix 1500 PLC and control the pulses to the motor via the two 20 KHz Pulse Width Modulation output found within Micrologix 1500.
Does any of you have a sample file or perhaps some comments on how to use this two High Speed outputs?
Any reply will be highly appreciated.
Thanks
Andy
Puerto Rico