B
I want to communicate Reactive Power Control Relay with P-CIM SCADA, but not serial, I want to communicate with MODBUS/TCP. Our RPCR output is rs485, when I use 485/TCP-MODBUS convertor, I have a convertor IP and a DSL IP (internet communication IP)
When I animate with P-CIM SCADA what I want for data, how can I address these data?
Example: At Modbus Serial Addresses: 1:1:40001
At Modbus-TCP, how can I communicate? What addresses do I write at animation area?
Thank you so much.
When I animate with P-CIM SCADA what I want for data, how can I address these data?
Example: At Modbus Serial Addresses: 1:1:40001
At Modbus-TCP, how can I communicate? What addresses do I write at animation area?
Thank you so much.
