Control

RS-485 to 4-20mA conversion

C

Thread Starter

CliffordJ

Are there any devices available which will break out signals transmitted via Modbus over RS-485 into 4-20mA outputs? I need to extract signals from the RS-485 output from my sensor unit/s and provide these in the form of 4-20mA outputs.

Regards
Clifford January
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
B Modbus RS-485 Checksum and insufficient bytes received errors Modbus 9
A New to modscan. I am trying to talk to an analyzer using 2 wire rs-485 this is the data response I get Modbus 4
E analog signal 4-20ma/0-10V to rs232/485 by modbus RTU Modbus 2
S RS-485 to 4-20mA conversion General Communications Chat 7
V Device for converting RS-232/485 signal to 4-20mA General Automation Chat 5
Similar threads
Modbus RS-485 Checksum and insufficient bytes received errors
New to modscan. I am trying to talk to an analyzer using 2 wire rs-485 this is the data response I get
analog signal 4-20ma/0-10V to rs232/485 by modbus RTU
RS-485 to 4-20mA conversion
Device for converting RS-232/485 signal to 4-20mA

You May Also Like

Top