I was trying to create new module in I/O Configuration and I get the "Fatal Application Error"
Below is my plc setup if I need to try to connect and do auto configure
1756-PA72 psu
1756-L1/A cpu ser: A F/W: 7 REV:11
1756-IF16A
1756-IF16A
Blank
1756-IA16/A
Blank
blank
1756-CNB/E
Blank
1756-OW16I
1756-A10 backplain
This is while not connected to the plc. Any idea what I'm doing wrong. I'm used to rslogix 500.
See below the steps that I followed
The Test file
https://control.com/forums/attachments/default_test-zip.2533/?hash=2b35ad7a001828a07c2b62ea7b5170d8
Thank you for your time
Below is my plc setup if I need to try to connect and do auto configure
1756-PA72 psu
1756-L1/A cpu ser: A F/W: 7 REV:11
1756-IF16A
1756-IF16A
Blank
1756-IA16/A
Blank
blank
1756-CNB/E
Blank
1756-OW16I
1756-A10 backplain
This is while not connected to the plc. Any idea what I'm doing wrong. I'm used to rslogix 500.
See below the steps that I followed
The Test file
https://control.com/forums/attachments/default_test-zip.2533/?hash=2b35ad7a001828a07c2b62ea7b5170d8
Thank you for your time
Attachments
-
74.9 KB Views: 1