Control

Running 24VDC and 220VAC Signals in the Same Cable

H

Thread Starter

Hassankh

For the output contacts of a field device we want to use a cable with 16 1.5mm2 cores. 10 signals are powered by 220 vac and four signals are powered by 24vdc circuits in the control room. I wonder if it's ok to use the wires of a single control cable for this purpose? The coil of the 24vdc relay has a nominal current of 24mA and that of the 220vac circuit is 6mA.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
Cyange PowerFlex 755HiP - Can I notice low oil level in the motor it is running with drive feedback? General Automation Chat 0
automation_whisperer PC running a RSLogix500 Program exporting information to another PC running iFIX software Programmable Logic Controller - PLC 0
W 9.5. Running General Communications Chat 0
Khac Sau GTG trip when started running WI with liquid fuel. Process Control 1
M High pressure distillate pump running on gas ignition, MS6001B with MKV. General Automation Chat 3
Similar threads
PowerFlex 755HiP - Can I notice low oil level in the motor it is running with drive feedback?
PC running a RSLogix500 Program exporting information to another PC running iFIX software
9.5. Running
GTG trip when started running WI with liquid fuel.
High pressure distillate pump running on gas ignition, MS6001B with MKV.

You May Also Like

Top